Gopro hero8 + ND filter mount

thingiverse

Work in progress, but getting there. Not pretty yet, however functional. Crashed my kwad twice, the mount stayed intact and more importantly the ND filter didn't go flying off. This particular ND filter clips on magnetically to its mount. So that being said, this tpu mount is essential. Meant to fit gopro hero8 with PolarPro ND Filter and mount to RotorRiot Flowframe. There is a strap hole, so you can mount it to whatever. Tilt is 30 degrees. The hero8 is still pretty new so ND filter options are limited, especially given the new form factor around the camera lends. These PolarPro filters seemed like the best compromise currently. PLUS acts as an additional lens protector. This ND filter can be found on Amazon, comes in a set. ND8, 16, and 32. Every way I have printed so far requires quite a bit of supports and some significant clean up work. The best print so far has been on its side (left side if looking at front), minimizing the amount of supports and clean up work needed. TPU 100% infill