GoPro MAX Slip Cover

thingiverse

The lens caps for the GoPro MAX provide very good protection for the exposed fisheye lenses, but are easily mislaid or contaminated while the camera is in use. I decided to try making a single part cover that would clip in place. Initially I was thinking about something spring loaded like a hair "clutcher" clip, but that would stick out above the camera to provide leverage to open it. So I decided to try something simpler. The cover simply slips over the MAX, held in place by gentle detent ramps either side of both lens shrouds. It doesn't offer good dust protection, just protection from abrasion of the lenses. The part prints great without supports. I use ABS on the Ultimaker S5, with Dimafix for adhesion to the heated glass bed. If you have trouble with adhesion, you may need to add a raft or similar.