GoPro mount for Garmin out-front mount

thingiverse

A mount to secure your GoPro under your existing Garmin out-front mount to eliminate the need for two separate mounts on your handle bars. I printed this at 0.2mm layer height in ABS. I would recommend ABS, nylon, or some carbon-reinforced filament, PLA is likely too brittle for this application. NOTE: you'll need some extra hardware/fasteners to integrate this safely, read below: Assembly: - remove your Garmin mount from the handle bars, remove the two M3x6 screws at the bottom of the mount. - place the gopro mount under the garmin mount and replace those two M3x6 screws with two new M3x12 screws, using washers, and some blue lock-tite on the screws to prevent them from vibrating out of place. - use some super glue to glue in a M5 nylock nut (with the nylon ring inside) into the hexagonal space left for it on one side of the gopro mount. - wait for this glue to dry then attach the garmin mount back on your handle bars. - attach your gopro to the assembly using a M5 hand-tightened screw that comes with most gopros and their accessories.