GoPro Mount for paintball (22mm 0.86'' diameter)

thingiverse

EASY TO PRINT and NO EXTRA TOOLS NEEDS This is a mount I use to attach my GoPro camera to my paintball gun's barrel. The barrel has (outside) diameter 22mm (0.86inch). The mount is design the way you do not need any support while printing - that's why corners are flat, not curved. Wholes and free space are a little bit bigger then in original GP mounts, to be sure everything goes smoothly. There are also holes for zip/cable tie (polski: trytytka ;) for additional protection for the GoPro. If you think It is usefull or there should be some changes, leave your opinion in comments. Instructions My instrucions are just demonstrative and they can be freely changed. To print my GoPro mount I use a PLA. The PLA is a good choice becouse the mount can be (a little bit) modify even after you print it. For example: 3D printer printed too tight/small mount and it cannot fit on tube/barrel, so you boil water and put the mount (just the end) to this hot water for couple seconds. Next, you pull the mount out of water and spread it (a little bit) by your hands. During the plastic (PLA) is warm, the mount can be strech and squeeze. I print it with 20% density - good enough to not break. Honeycomb pattern inside. Three (3) perimiters - just incase. Layer height: 0.2 mm (with 150% first layer) Default extrusion width 0.35 mm Nozzel 0.4 mm