GoPro Print Bed Mount

thingiverse

GoPro mount for the Ultimaker2 print bed. Simply slides on and off. Great for documenting your printing progress. Added a version for the Dremel Ideal Builder as per a request. Instructions Mount your GoPro camera to the moving bed. Mounts underneath the heated printing plate. Therefor heat will not effect the mount. The mount also clears the frame in full up and down positions. Glue the two parts together but it is not necessary as there is a good fit. Bed must be raised from advanced options to properly install. Re adjust your bed after installation. Possible to mount from side of bed closer to the supports. Use at your own risk. :) Print the bolted section with the 3 fins facing down. Print very slow in the first 5mm to avoid detaching the fins from the print bed. Use a freshly cleaned and leveled bed to print. I had best results on the rounds by printing on a clean and unheated print bed (PLA material used).