GoPro Tilt Mount for Armattan F1-5/6

thingiverse

This GoPro tilt mount is set at 27.5 degrees. It attaches directly to the existing mounting holes on the extra camera plate for the Armattan F1 5 and 6. Admittedly it's not the lightest accessory out there, but then neither is your GoPro, so if you're racing, you should probably take them both off. *the velcro slot is a tight fit, but does work. Should accept up to a 20mm strap as long as it isn't unusually thick. I used a small flathead screwdriver to feed mine through, about 3/4 of a cm at a time. Print Settings Printer Brand: Printrbot Printer: Simple Black Rafts: No Supports: Yes Resolution: 0.2-0.3mm Infill: 25% Notes: Printed in PLA. ABS should work fine, but with the usual ABS issues. Supports are required under the main gopro holder. Make sure there are NO supports printed inside the slot for the velcro strap to attach the gopro...you won't be able to remove them once the print is finished.