Graded Card / Slab Necklace for CGC/CSG slabs

thingiverse

Compatible with current CGC and CSG Slabs as of May '22. Edited 31May22: Rev2 is the latest release of the housing. I rounded the corners and made it smaller to fit the slab a bit better. I also added a 4mm hole that is 20mm long to attach to the housing which helps prevent the housing/graded card from spinning when worn around the neck. Note: I don't own PSA or BGS or other graded card slabs. So, I can't say it's universal. Feel free to re-mix this to make it compatible with other vendors' slabs, just attribute the original design idea to me. I was inspired by "The Logan" necklace on Etsy, however, I wanted to make my own and make it easy to print. Printing: Be sure to print with a soft but rigid plastic material such as normal PLA or PLA+. You don't want to end up harshly scratching your graded card slabs. Warning: USE AT YOUR OWN RISK, I WILL NOT BE RESPONSIBLE FOR SCRATCHES ON YOUR GRADED CARD SLABS. Installation: https://youtu.be/IwKgto453c4 Slide and hook the graded card slab under the top tab (either way) of the slab holder and press down firmly on the slab, the sides of the housing should bend slightly, and then the slab should be securely installed once pushed all the way in. You may or may not scratch the side of your slabs depending on how hard the filament was that was used to print the slab necklace housing. USE AT YOUR OWN RISK, I WILL NOT BE RESPONSIBLE FOR SCRATCHES ON YOUR GRADED CARD SLABS. Materials: 1. Sand Paper (to sand down sharp edges) 2. Good performing Crazy Glue (to secure the top portion to the main slab holder necklace)--I used Loctite Super Glue 3. 2mm line/rope for the necklace to secure around your neck Recommendation: I recommend testing out with a slab where you don't mind scratches on the side of it, just in case the housing does scratch the slab (ie. a low graded/non-expensive card). In my experience, even with PLA+, I noticed no obvious scratches on the side of my slabs.