GRBL CNC DB25 Breakout Board Mount

thingiverse

FUSION 360 Files included! Partner Parts: https://www.thingiverse.com/thing:3876826 The DB25 Breakout (non-isolated) is intended to go from the electronics enclosure to the CNC machine or 3D Printer.. Breakout Used: (make sure to order a male and a female) https://www.ebay.com/itm/DB25-D-SUB-Female-25Pin-Plug-Breakout-PCB-Board-2-Row-Terminals-ConnectoODFS/113888514165?ssPageName=STRK%3AMEBIDX%3AIT&var=414158498618&_trksid=p2057872.m2749.l2649 The idea is to allow a 25ft Paralell cable to serve as the primary wire for the CNC to eliminate that spaghetti wire. I have a few machine self made and a 3018 CNC from China. I will be adding this to the machine to remove the electronic from the back and into an enclosure near the operating PC. The 3018 has the upgraded 500w spindle seen here. There will be a cover created for this part but I am not to that stage yet... https://www.thingiverse.com/thing:3876546 Assembly note: Put the DB25 connector into the mount and press down gently to imprint the foam against the tab the rear screw hole rest on. This will leave a slight indentation in the foam to indicate a precise cutting point to remove for a snug fit!