Greek Meander Ledberg bottom (70% scale)

thingiverse

Greek Meander Lamp bottom at 70% using Ledberg LED --------------------- I printed the Greek Meander Lamp at 70% scale and wanded to use an Ikea Ledberg. This is the result. ### Notes The bottom comes with four snappers, so you can clip it into the meander cube without the need to glue it. The Ledberg PCB is a pretty tight fit, be sure to connect the cable before pushing it into the part. The "ringV1" glare shield is only one wall count thick (0.4mm), so it's translucent. But it's also very fragile. Take care it doesn't break. The diffusion dome should, obviously, be printined in some very translucent material. **Please note**, though, that using a diffusion will greatly affect the clarity of the meander projection on the wall. You can also try fitting the original Ledberg lense on the "ringV2"...could fit but didn't try yet. ### Variants There are four variants: meander_bottom_ledberg_70.stl: Just the plain bottom fitting a Ledberg PCB meander_bottom_ledberg_70_ringV1.stl: Bottom with added thin glare shield meander_bottom_ledberg_70_ringV2.stl: Bottom with added thick glare shield meander_bottom_ledberg_70_dome-holder.stl: Bottom with added snappers for diffusion dome meander_bottom_ledberg_70_dome.stl: diffusion dome ### Material I used "green-gold" PLA from Das Filiament for the base and transparent PLA for the dome.