Green Lantern Mask (Thicker)

thingiverse

I was asked to upload the altered file I used by a couple of users, so here it is. I just thickened the original file using meshmixer so the file would print the mask and not just support material, which the original model did for me. (Made it more printer-friendly.) You should be able to scale the X to your face width (at the temples [either side of your eyes]) in millimeters (may want to add 1-2 mm to ensure a good fit.) I scaled it up a bit too much (my face is 125 mm at temples, and I scaled it to 135 mm... so - too much) on my first print, and had to use 8 layers of 1mm craft foam glued inside to hold it in place (pictured), which is not such a bad thing as it's softer than plastic, but 8 layers seems like overkill. The scale I used also makes it a bit long in the nose for me. I printed this with 10% infill in PETG and I used supports to ensure it would print properly. I'll be printing another one soon with better scaling. Props to buchsixghoul for such a great design!