ReRemixed Wowstick Desktop Stand

prusaprinters

<p>A stand to store your Wowstick and bits on your desk.</p> <p>This is a from scratch redesign in Fusion 360 of the original thing:2893136 by vanilla_thunder and the previous remix thing:3085888 that I did. The original source design by vanilla_thunder was designed with Tinkercad.</p> <p>The goal with this redesign was to make it not need supports, Fix bits being too tight in the holes, The top rounded (for safety), Make sure the holes for the bits are aligned, Hold the wowstick a little better in place, and to allow a bit to stay in the screwdriver when putting it on the stand. I tend to use the same bit a lot so got tired of taking it off all the time to put it in the old stand.</p> <p>A big thanks to the original thing design as I really like the basic triangle design of it.</p> <p>I also included the fusion360 file for easy modifications.</p> <p>I might add a wall mount version if someone wants that, like the original thing design.</p> <p>Changes from my previous remixed thing version...</p> <ul> <li>Rounded top to make it safer</li> <li>Holes for the bits are now aligned precisely</li> <li>Bigger and more form fitting holder underneath the Wowstick so that it is not as wobbly.</li> <li>Taller mount underneath the Wowstick to allow a bit to stay in the screwdriver when putting it on the stand.</li> <li>Use a 45 degree angle for the open area under the wowstick so that supports are not needed.</li> <li>Lower kickstand in the back to reduce the chances of needing to put manual supports in to hold it up during the print.</li> <li>Slightly bigger holes for the bits as they were a little snug for me. I wanted them to slide in and out easier.<h3>Print Settings</h3> </li> </ul> <p><strong>Printer Brand:</strong></p> <p>Wanhao</p> <p><p class="detail-setting printer"><strong>Printer: </strong> <div><p>Duplicator9</p></div><strong>Rafts:</strong></p> <p>No</p> <p><p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div><strong>Resolution:</strong></p> <p>0.2 mm</p> <p><p class="detail-setting infill"><strong>Infill: </strong> <div><p>20%</p></div></p> <p><strong>Notes:</strong></p> <p>No supports needed.</p> <p>If you have build plate adhesion issues on your printer then you might want a raft or custom supports around the kickstand in the back so that it doesn't fall over during the print. I have printed 4 of them so far and never had an issue with it though. I print without support and without a raft.</p> </p></p></p> Category: Tool Holders & Boxes