Grid for Godox AD360II Flash

thingiverse

This accessory provides the AD360II with a basic grid to limit the spread of light. The grid supports the bayonet mount of the AD360II, and should theoretically work with the AD360 as well, though you'll need to use the locking knob on the flash to fix it into place since there is no bayonet mount on the AD360. The honeycomb pattern has a 1.2mm wall thickness and 20mm depth, which should theoretically cut off light when pointed 20 degrees away. The diameter of this grid is only 50mm, which puts it in close proximity to the bulb, so I would be careful when using this accessory during extended periods of flash use or high speed sync. The overall length of this grid is 100mm, so smaller 3D printers, such as the Malyan M200, can print this accessory. I'll upload other variants (larger diameters and different angles) in a bit. Recommended orientation (to reduce need for supports) is with the grid pattern as the base; this should eliminate the need for supports inside the larger barrel. You may need supports for the bayonet mount, however. Print Settings Printer: M200 Rafts: Doesn't Matter Supports: No Infill: 20%