Guitar Pedal Board - Printable on the MP Select Mini (120x120x120)

thingiverse

Works best with mini pedals but also works with some standard-sized pedals. See the images for guidance on how all parts fit together. For my setup I printed 3 X pedalboard_section, 4 X x_brace, 4 X x_brace_end, 2 X pedalboard_end_slanted <h3>Print all parts first and perform a fit test before you start gluing any of them!</h3> (I used Krazy glue, it works well so far) pedalboard_end_slanted is a bit wider than the protruding ends of x_brace_end should be if the x_brace parts are centered between pedalboard_section parts, this allows some leeway without having x_brace_end parts protrude too much past the end parts, but a fit test is recommended for best results. x_brace_end may be a tight fit into the pegholes of pedalboard_end_slanted. I resolved this by shaving the corners of the ends to be inserted slightly with an xacto knife - you can also try rescaling the part (without uniform scaling) and making the X or Z axis ~5% smaller