Gun Stock for the HTC VIVE for Onward.

thingiverse

Hello fellow 3D print and VR fans. I´m a huge fan of VR Onward. So i designed this stock for the HTC VIVE. It is important that you can raise and lower your cheek rest on the butt stock to fit the sight /scope on the rifle you get hold of. You can add some rubber bands to adjust how hard you want it to be to move the cheek rest up and down. It is also important that you can slide the two controllers in and out to adjust the distance to your rifle sight and the distance to your forehand grip. But one size almost fit all rifles. I designed the gun stock so it is easy, fast and cheap to print. Just print the two controller holders. Left and right hand is the same stl. Print two butt stock bottom and one butt stock top. Remember support. except on "butt gun top" and "hooks" I added a Hook under your "trigger finger" so you can hold your rifle loose without dropping it. To limit the amount of support i made this hook in a stl alone. Just glue the hook on after print. Go get a iron pipe, size almost don't matter. Add some rubber bands and you are good to go. It is good to make the iron pipe a little longer than where you put the front controller. It feels better and will not make your rifle feel so heavy in the back end. A heavy iron pipe also "feels good" In Onward. Just use proximity grip and rip out the controller when you need to use your hand. Put the controller back and you automatic grip your rifle again.