HackRF Portapack H2 case

thingiverse

This is a case for the awesome Portapack H2. The Portapack from _ShareBrained_ is an add-on for the HackRF. The HackRF from _Great Scott Gadgets_ is a Software Defined Radio peripheral capable of transmission or reception of radio signals from 1 MHz to 6 GHz. NOTE: There are some reports that if you have the genuine HackRF, you might need to print the pieces at 101% or 102%. The case is designed to be tight, but not extremely tight. NOTE2: The revisited files should not require any modification. They are an improvement over the original files: 1) less tight fitting 2) better sd card slot 3) bigger holes for reset and dfu button 4) better fit, specially on the 2 bottom SMA #Parts * **HackRF+Portapack H2+battery** (clone): https://s.click.aliexpress.com/e/_dSMPvNo * Screws (M2.8x10mm and M2.8x8mm): https://s.click.aliexpress.com/e/_dSS6UAQ * [optional] 3d printing pen (to fill the led holes with translucent material): https://s.click.aliexpress.com/e/_dUZEpXk # Extras * For the **speaker** I used one from an old lenovo laptop. Connect the yellow and red wires to the speaker and leave the black wire floating (from the H2 kit). The speaker was attached with thick foamy double sided tape under the left side of the LCD. * The **battery** was attached with thin double sided tape, in the middle of the 3 sets of pins of the Portapack pcb #Video https://www.youtube.com/watch?v=9VhhOtr-MG8 Speaker test: https://www.youtube.com/watch?v=XkaGV9muvbg #Related links * Get the genuine HackRF: https://greatscottgadgets.com/hackrf/one/ * Get the genuine PortaPack H1 (not compatible with this case): https://www.sharebrained.com/portapack/ * Custom firmware: https://github.com/eried/portapack-mayhem ______________________ #Changelog * 2020-04-06: Updated up and down pieces for better fit between them, nicer alignment with the status leds and micro sd card * 2020-04-11: Updated down piece with extra slots for pins in the hackrf and stronger middle piece between the two CLK SMA and up piece with small tweaks * 2020-10-07: Uploaded revisited versions of all the pieces. Check the NOTE2 on top * 2020-12-12: Uploaded improved ones for weeerg.com services or similar SLS printing services. Please use this files if you are using a high resolution service. * 2020-12-18: Holes for the buttons on the weerg version slightly smaller