Hackrf Portapack top plate

thingiverse

I needed a top plate for my portapack, which would also add bumpers to the sides of the display, hopefully preventing anything from cracking the screen. As I was checking it out, I noticed it was sitting up on edge. I laid it down flat so I could actually print it! Although, you get bonus points if you can print it without any support! I want to give a shoutout to the people who made this possible. https://twitter.com/sharebrained https://twitter.com/michaelossmann Post-Printing: The top plate fit pretty snugly in place. I based my design on the CAD file for the circuit board. However, you'll need to sand down the bottom edge a bit after the first layer squishes. Additionally, I found that I had to drill out the screw holes slightly, which might be due to a slight miscalculation with my scaling.