Hadron power supply mounting brackets

thingiverse

These two parts allow a 12V power supply to be mounted directly to a Hadron Y axis. The front bracket fits into the tee slots of 40 X 20 Open Rail and the rear bracket requires two tee nuts and screws to mount to the rail. The rear bracket also covers the wire terminals and anchors the mains cord. It will fit power supplies 215 long (approx.) and 114.35 wide by 48.6 deep. The IGS file is included if you need to tweak the design to suit your power supply. Instructions When fitting permanently, use a little double sided tape to stop the metal case from sliding sideways at the front bracket.