Half and Half Pint Carton with Threaded Spout

myminifactory

This is a 1:1 scale model of a pint sized half and half carton commonly found in the US. It has threads on the spout, but the cap from an actual half and half container doesn't screw on properly. (That was the goal, however.) Still looks good. The inside sloped bits are connected to the underside of the outer sloped bits by just the tiniest amount. If you push down on them, they may separate. Printed in PLA on a Creality CR-6 SE quite nicely at .16mm layer height. The very bottom of the lowest forward thread under the spout had a bit of a misprint, as I didn't include support. That is the only place support could be necessary. Overall a fun print.