Handle and Hanger for Elegoo Mars

thingiverse

Here is a handle design so you can lift your Elegoo Mars cover without touching the sides with dirty gloves! I also made a hanging plate so you can hook it to a screw head on any wall and have your machine free to work on inside without cover in way. It might fit on other resin printers, just verify the size. I use two types of M4 screws with button cap: M4 x 24 @2 M4 x 12 @3 M4 nuts @6 washers @6 here's a handy set (affiliate link): https://amzn.to/2l3a0gx I printed in PLA with 3 outlines and 30% infill. I printed the wall plate flat on its back, no supports and the Handle in the upright use position with supports under center of handle. Screen shot of build plate attached. I designed it so the screw holes are close the the edges for more support and less chance of cracking. To drill I recommend this process: put down masking tape across general areas. Mark center lines for holes and double check. Drill with a small bit about 2-3 mm or 1/8, do not push, let the drill cut the material. Re drill with a larger hole about 4 mm or 11/64 for final hole. Push screws through printed parts and through cover, back with washers then tighten down nuts. If you love this please let me know and post your make!