Handle bar signal lights

grabcad

*Quick concept model so dimensions may not reflect standard bike structure tube ID or OD Design to facilitate visible turn signals on a standard bicycle as well as to increase visibility in low light situations. Set of units will be inserted into the end of tube type handlebars. Each unit will consist of a battery cap (gray) , battery compartment (black), Red LED area for signaling (red) and push button (black convex) Installation: Insert batteries (AAA or AA) into the battery compartment, creating a water tight seal with cap (O-ring) then inserting into handlebar ends. Operation: -By tapping the button once the unit will strobe at a steady rate to indicate intention to turn. One tap will stop strobe activity. -By holding down the button the unit will turn on and stay on to maximize visibility in low light situations. One tap in this state will begin strobe, one tap will stop strobe. Unit will be turned off by holding down button again. Other functions can be incorporated, an example would be strobe speed could be adjusted.