Handyhalter / Smartphonehalter V2 - Updated Version

thingiverse

Letzte Änderung: 18.03.2020 WARNING ! The small cube will be printed from TPU. Please align the support structure blocker at the holes, otherwise they will fill up and you won't be able to press in the TPU cubes anymore. V2. Maximum Smartphone Thickness: 10.5 mm V2. Changes: It has another hole (back) for a different tilt angle of the smartphone (maximum thickness 15 mm). Holes were reduced by about 0.5 mm; the impression was shifted; small rubber feet can be printed with TPU, so that the smartphone holder no longer slides on the table (hole at the bottom); rounded corners were changed. My Print: Temperature: Nozzle: 200° Heated Bed: 60° Printing Speed: - 50mm/s (Outer Wall: 20mm/s; Inner Wall: 50mm/S) Motion Speed: 120mm/s Intrusion Speed (Filament): 30mm/s Cooling/Fan Speed: 80% Combining Mode: All Support Structure: Please align the support structure blocker at the holes (below), otherwise they will fill up and you won't be able to press in the TPU cubes anymore. Touch Bed... Angle: 55 degrees Support Bottom Activated