Hanging plant support ring

prusaprinters

<p>This ring is designed to be used with 4mm paracord. Cut the length of cord you need to fit between your pot and where you intend to hang it from and thread it through the holes, you will need 8 lengths of cord. Tie a knot above the top ring to stop it falling off. You will need to print as many rings as you need to span the gap, and provide enough support. The cord should fit through the holes in the ring tightly, so no need to tie them off. If your cord is thiner, you might need to tie them, although its designed so that the rings can be adjusted up and down as needed.&nbsp;</p><p>Print without supports in speed setting.&nbsp;</p><p>I printed mine in a matt green colour that matched my cord very well, and will be somewhat hidden once the plant grows, however you can be as bright and creative as you like when it comes to colour.&nbsp;</p>