Harbor Freight Dial Indicator Holder for Chimera Mount

thingiverse

I was having a hard time tuning my first delta printer, an He3d K200. I wanted to mount a dial indicator, but all I could find were ones designed for single hotends. I have a dual - the hole patterns are different. I found a mount that looked good and remixed it here to mount onto the effector. You do have to remove the hot end to use this, but it puts the dial indicator pretty close to center. You also have to change your z max height, so it can go low enough to reach the bed. This was designed for my K200, but should work with any printer where you have access to mount above where the hot end goes, and that will let the bed get close enough (that would probably include most deltas, but not necessarily most cartesians.