HB-20 compatible Lens Hood for Nikon 28-80mm

prusaprinters

<p><strong>Short introduction</strong></p> <p>Had an old 28-80mm Nikon lens laying around which did not have a lens hood. So I decided to design one. I tried to imitate the original HB-20 as close as possible by using reference images I found on eBay.</p> <p><strong>About Tolerances</strong></p> <p>If it is too tight on you can try the "horizontal expansion" setting in Cura with a negative number. Same if it is too loose (but with a positive number this time).</p> <p>Afterwards you might want too remove the strings (because of the missing supports) or shave some material off with a sharp knife to help everything fit.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Creality</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Ender 3</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.2mm</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>20</p></div> <p><strong>Filament:</strong> DAS FILAMENT PLA Black</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>Supports may be necassary for the reversability of the hood. I was able to do it without.</p></div> </p></p></p> Category: Camera