Headphone mount for GearHead Strap

thingiverse

This is based on the: Quest 2 Headphone Adapter (Sony ZX110) https://www.thingiverse.com/thing:4632334 by SolidRye to mount the: Sony MDR-ZX110 or MDR-ZX310 Headphones to the: GearHead Strap for Quest 2 https://www.thingiverse.com/thing:4815973 by AdamAndEvil using part of the Side_Hair_Shield It slides in the side "Rail" of the headstrap so they can move back and forwards to adjust to your ears They should fit fairly tight on your ears if they are too loose these headphones sound quite tinny You can carefully cut off the rubber piece on the cable and then remove the earpads and the two screws under them to open the housing of the headphones wich allows you to pull the cable into the housing where you can tie a new knot on the cable and coil it up inside (leave about 30cm/1foot for the left and about 60cm/2foot for the right side) so its stored safely and not dangling around (you can also cut and resolder the wires but this is the easiest way imo) Update 19.12.21 Added a version with additional mount for a AntlionAudio Modmic by subjektiv_dk https://www.thingiverse.com/thing:3024912 needs a 6x2mm Magnet as of posting this i havent jet printed this version