Headphones desk support/mount/holder

thingiverse

I designed this because I wanted a minimalist support for my headphones, to keep them away from sight, but, at the same time, easy to reach. All you need is to print this and use 1mm thick double-sided tape. I'm using the Tesa brand. It holds up very well, there's no chance it will fall on its own. There's a 1.5cm tall groove on the back of the support where you should place the double sided tape. I designed that as a groove to try and hide the tape as much as possible. Chances are your tape will be a bit wider (it my case, it was 2cm wide), but you can easily cut off the excess.