Heat Block Silicone Insulation Mold for ZONESTAR Z9M3

cults3d

With this mold you can make a Heater Block protective silicone cover. How to do it. print Inner and outer mold in ABS or ASA. Fill outer mold half + with heat resistant silicone, make sure to come out to the edge, and do not fill the center hole. Now place the outer mold on a smooth surface with the small hole facing down. Press the inner mold down into the silicone and the small hole on the outer mold, it must be pushed so far down that it meets the surface. The silicone should now have penetrated the top in between molds. Excess silicone should be smoothed out and removed. Allow the silicone to harden as directed by the manufacturer. (Usually 24h. However, I leave the hardened almost twice the time to be completely safe.) When the silicone is dry, remove any excess plastic from the mold, taking care not to damage the silicone. Insert mold into acetone until mold is dissolved. Remove any excess plastic that has not dissolved, wash the silicone. </p> You should now have a Heater Block protective silicone cover. There should be three cutouts with a hole at the end, two small ones and one large one. If not remove excess silicone. You can now put the silicone cover on the heat block. the large hole fits with the heat pipe Have fun.