Height and tilt adjustable cell phone and tablet holder.

cults3d

Here is a height and tilt adjustable cell phone and tablet holder. Print the button twice. Two M5 inserts and 2 M5x10 mm screws are required. Printed with PLA, 4 wall lines and 25%-50% infill. If you want the base heavier, increase the infill or add sand during printing. The trays come in different sizes: 12 mm, 15 mm, 20 mm, 23 mm - depending on how thick the phone or tablet is. The tray is glued to the clamp part2 using, for example, super glue. I am open to upgrades / suggestions for improvement. Edit: first upgrade the knob for a M5 nut if no insert available. The opening is a bit smaller therefore turn the nut on a bolt, warm it up with lighter and push it in. Height and tilt adjustable cell phone and tablet holder. Print two button, you need two M5 inserts and 2 M5x10 mm screws. Printed with PLA 4 wall lines and 25%-50% infill who likes the base heavier increase the infill or fill it with sand during printing. The trays are in different sizes 12mm, 15mm, 20mm, 23mm depending on how thick the phone or tablet is. The tray is glued to the clamp part2 using e.g. superglue. For Upgrades / improvement suggestions I am open. Edit: first upgrade the knob for a M5 nut if no insert available the hole is slightly smaller therefore turn the nut on a screw, warm with lighter and press in.