Helium Mapper Case for Heltec CubeCell (HTCC-AB02S)

cults3d

UPDATE 2/10/22 - Added a new lid version with much better buttons and a few tweaks to facilitate printing. Doing a filament swap does a nice job of highlighting the logo and button icons. Quick remix of philltran's mapper enclosure to address some issues using a higher gain GPS antenna (tested with https://www.amazon.com/gp/product/B078Y2WNY6), add an external SMA connector (https://www.amazon.com/gp/product/B07NVT8FMT or similar), and permit a larger selection of batteries. Took the opportunity to tweak a couple surfaces and throw a little branding on it but would still like to improve the buttons and make them a bit more tactile and add retention clips for the board...perhaps in the next version. Note that different GPS antennas may require changes to the slots/guides for clearance and thicker antennas may need to go on the side as in the original design, I located it on the top for optimal reception when on the dash of my vehicle. For information regarding building a Helium Mapper check out the #mappers channel on the Helium Discord or the following links:https://www.helium.com/mappershttps://mappers.helium.comhttps://docs.helium.com/use-the-network/coverage-mapping/https://github.com/jas-williams/CubeCell-Helium-Mapper