Hellbot Magna Dual V1 / Geeetech A10M - Marlin 2.1.x Firmware WITH 3DTouch installed (Spanish / English versions) FIXED!!!

thingiverse

UPDATE 08/07/2022 : 2 BUG FIXED (Power lost recovery working, S Curve working well) It is tested but using without any warranty and onto your own risk!!! Hi there, I'm from Argentina I made this firmware because I bought a new Hellbot but stock firmware was too old (Marlin 1.1.8), so I decide to create an update to the last Marlin firmware bacause it have a lot of improvements Firmware Marlin 2.1.x for Hellbot Magna Dual V1 and Geeetech A10M 3D-Printer WITH 3D TOUCH and original drivers installed !!! - Language: Spanish (first RAR file) / English (second RAR file) - Manual bedlevel over 25 points activated - Automatic z leveling at printing - S curve acceleration ON for best printing! - Sourcecode included NOTE: if you want to change the original driver to TMC2208 or TMC2209, you only need to invert step motor wired in only one side as shown in the pictures 2 (original) and 3 (modified), step motor side or motherboard side!!! To install it you need Arduino software, go to the Marlin folder and open Marlin.ino, then press Verify button and when finished press UP button. Its done! I was using this firmware and I tested it, all working without any problem and add many new functions. If any need to change any parameter of this firmware for Hellbot Magna Dual or Geeetech A10M, for example if you dont have 3DTouch sensor, let me know and I'll try to upload it shortly Enjoy!!!! It is tested but using without any warranty and onto your own risk!!!