HEVO parts for gates idlers

thingiverse

These are some remixes of parts for the Hypercube evo for using Gates idlers. The idlers are held in place by 5 mm axles. Drill out the holes with a 5mm drill to get a good fit. The axles have to be pressed in place and are held in place by friction. Be careful to not damage the bearings in the idlers. The XY idler needs one normal print for one side and one flipped for the other side. The XCarrier is like the original cleverly designed and work on both sides, just turn it upside down. It's made for 10mm Y rods, and 8mm X rods. Both big parts needs a fair amount of support material and might need some filing to make the idlers fit and run smooth. It's a tight fit. If I remember right it's the thin X flag that fits. This is and old design that I have used for over half a year.