Hex tray for Ikea Tisken corner basket.

prusaprinters

<p>I designed this tray to attached underneath the Ikea Tisken corner basket. The size of the hex pattern is wide enough to hold my razor which is a bonus.</p> <p>My setup:<br/> 1 x tray<br/> 3 x bolts<br/> 6 x nuts (maybe 9, see note below)</p> <p>1.Drop in bolt from the inside of tray and screw in a nut with round end facing the bottom of the tray. This will lock the bolt and prevent from moving up/down. Don't tighten all the way yet.<br/> 2.Place a nut inside the corresponding hex on the tray, screw the bolt into it until flush with the other end.<br/> 3.Tighten the nut from step 1.<br/> 4.Repeat above steps for the remaining bolts.</p> <p>note:</p> <ul> <li>if the hex nuts fit loosely inside the tray holes from underneath you can print another 3 to tighten against the top of the tray (round end facing against the tray)</li> <li>orient the nut in your slicer with the round faced down</li> <li>orient the bolt in your slicer with the round end faced down.</li> </ul>