HGLRC XJB-145 Jumper R1 Receiver and Antenna Mount

thingiverse

This thing is a mount for a heat-shrinked Jumper R1 receiver on a HGLRC XJB-145 drone frame. It is supposed to replace the stock camera mount. The two antennas can be mounted to the front with two cable ties and some heat-shrink tubing. There are some notches to hold the receiver PCB in place. I've additionally put a drop of CA-glue between holder and heat-shrink. The images show a slightly older revision. I made the slots for the cable tie a little bit thicker and the walls on the side a little bit higher. You need four long (> 10 mm) M2 screws to mount this. There is an optional fifth hole in the center for a short counter-sunk screw. It's supposed to be printed with TPU for extra durability.