Hockey stick but end

thingiverse

Ice hockey stick butt end for my Warrior QR-pro. Not sure if it will fit on other sticks. Just remove the plug in the end of your stick and carefully push this into its place. Tape it to your stick starting half on half off then spiraling up to the end to give good grip. This is designed to be taped on so don't try using it with your stick without tape or it will come off or break apart This will add 4-5mm to the length of your stick. Print without support with high infill. Have the butt/knob end, face down on the print bed. Works well with a 0.5-0.4mm hotend, anything bigger wont print the shaft section.