Hockey Stick Holder Wall System

thingiverse

Hockey sticks kept being knocked over, so I decided to design a system that could be used to print a hockey stick wall holder for almost any length. There is a start and end piece, and you can print as many middle pieces as you need. There is a little tab that joins the pieces together (a little sanding may be needed to make sure they fit well) which will further reinforce the structure. I used two-sided tape to stick the things to the wall and small screws (one each for the middle pieces and two for the ends) to fasten them to the wall. 3mm holes are provided in the design. The "rack" once complete keeps the sticks nicely in place, with the little "dot" on the side walls. The sticks fit loosely, but stay inside and are easy to remove.