Holder for 12V to 5V Power Converter Guts

thingiverse

Chopped it up a bit to fit a small cig lighter power converter guts. Its small enough that it really only needed three tabs. This will be mounted to the side of a Deltaprintr to power a neopixel array and the arduino nano that controls it. I doubt anyone else will have the same form factor as I do but you can at least use the enclosed file as a starting point. The width of the board space is 15.5mm (so your board should be slightly wider than this, or you can use some hot glue to secure) The length of the board space is 24.6mm -- if your board is longer than this it will stick out the end (which I did on purpose but be aware)