Holder for Xiaomi Mi5+silicone case. gopro support

thingiverse

This is a holder I made exclusively to match with my smartphone Xiaomi mi5 coupled with a thin silicon case. I use it on my motorcycle with gps mode. still ok after 3000km. on the top: 2 holes, and an exagonal housing, to "lock" the system with screw M4. At the end, I don't need it. on the bottom: - 2 holes to drain the rain water - 1 hole to plug the cable if necessary on the face: 2 vertical slots, to reduce the pressure of the wind and cool the batterie on the back : - an attach "gopro type" cause I already had the base on my motorcycle - a "safety arc", I wanted it at beginning to attach a little rope in case of breaking, due to the pressure off the wind. - a little window, 2.5mm thin. I had some plexiglass sheet, then I decided to make a window for the camera. the window is good, but the camera of the phone is too low, so movies results are bad lol. Printed with ultimaker 2go, so I had to split in two pieces. with a drop of glue, it's welled assembled.