Home DIY - Magnetic Remote Holder

cults3d

I had a classic remote controller for some led strips i used in the backyard, that was always difficult to find when needed ( I know, is always like that! ). Needed some easy solution for the remote storage, so I think at a magnetic support to attach it to the fridge, in order to be easy to find and store! I used three round magnets of 10x3 mm ( a little oversized...but it works! ), and embedded them directly inside the support during the printing time; the magnets are not visible at the end of the print. I just saw there are other similar supports on thingiverse, but the magnets are just glued on the back of the support, so my solution is something different... I hope you enjoy it!