Honda Key (FOB combo) Replacement with LA Angels logo

thingiverse

I made this key to replace the hollow key/fob combo on a 2006 Honda Pilot. The old key fell apart, so I designed this instead of spending $100 or so for the replacement. I just dug the chip out and printed this design and glued it together with the key and chip inside (the pockets are designed in. The FOB is separate and is also glued together. Somebody should probably remix the key part to remove the design so it can be printed without support, but I didn't mind digging out support to get the design I wanted. The FOB would be a bit trickier I think. Sorry I don't have a picture of the original key. Print Settings Rafts: Doesn't Matter Supports: Yes Resolution: .15 Infill: 100% Notes: I printed in ABS using 100% fill. Post-Printing The key is separated by unscrewing the small screw in the back of the key. Then you carefully dig the chip out from the housing on one side. It's pretty obvious where it is. First you remove the cap then dig the chip from the glue. I did this on two different keys without damaging the chip, but I'd still be careful.