Honeycomb Smart Wallet With SD Card Slots

prusaprinters

<p>This is a remix of a design from Thingiverse by b03tz. Link to original: <a href="https://www.thingiverse.com/thing:3097272">https://www.thingiverse.com/thing:3097272</a>. I changed this wallet to have a honeycomb pattern on the front and back and no logo(it also nicely holds your SD cards and keeps them organized). On the side for cards, you can fit 5-6 cards in there, in the front section, there is room for coins, cash, or anything else you carry. You can pick the normal middle layer, the one for 3 full-size SD cards, 8 micro SD cards, or one that holds both(2 full sizes, 3 micros). I know most people aren't walking around with 8 SD cards, but the spaces are there just in case. There are cut-outs inside that you can fit them in.</p> <p>Assembly:</p> <ol> <li>Cut off three one centimeter pieces of filament</li> <li>Insert the filament into the holes on the inside of the bottom cover</li> <li>Line up the hole on the lever with the cylinder on the inside of the bottom cover</li> <li>Line up the inside section holes with the pieces of filament sticking up from the bottom cover</li> <li>Slide the lever so that it is at a 45ish degree angle</li> <li>Put the rectangle on the top cover in the rectangle slot on the lever</li> <li>Slide to close</li> </ol> <h3>Print instructions</h3><p>Print flat, no supports.<br/> Print one of each:<br/> -Top cover<br/> -Bottom Cover<br/> -Inside Section<br/> -Lever<br/> Tip: If you use a textured print sheet on the bottom and top covers, they will look and feel better. If you use the textured sheet, you may want to use a little bit of glue(even though you're not supposed to). The hexagons have such little surface area that sometimes they detach from the surface and slide off, ruining the print.</p>