Hooked spinner

thingiverse

Printing is a breeze, just use a few lines of brim and you're good to go. I printed slowly at 30mm/s and 0.15mm layer height because I used Meltink3D Glow filament, which is incredibly hard and prone to stripping if pushed too fast. The finish is superb, with a mesmerizing glow effect - blue for the glow filament and grey for the Raptor PLA, printed at 0.2mm and 60mm/s. Grey represents the original model, featuring oversized holes and symmetry errors that I corrected, plus hole diameters shrunk from 22.148mm to 22mm. The shape makes it easy to spin, and with its substantial 7.6mm thickness, it's a weighty spinner that keeps going for days - 2 hours and 20 minutes with the right bearings.