Hornady Comparator Box V2

thingiverse

This is a new version of my Hornady Comparator Box that uses my new low profile Snug Hinge and Latch to allow a much thinner box top. These latches snap into a locked position when the lid is closed and you press them towards the box bottom. Print time is greatly reduced because of the thinner box top and that I noticed that the box bottom had tiny gaps, which I removed, that were causing unnecessary internal perimeters. Assembly Instructions: 1) Slide the hinges over the hinge pivot pins of the box top with the slot in the hinge facing the box top and the locking tabs pointing down and tilted inward 45 degrees. 2) Pivot the hinge tabs so that they point down and place the box bottom under the box top so that the hinge fixture hoops are aligned with the hinge tabs. 3) Carefully, press the the hinge locking tabs into the hinger fixture hoops until they lock into place. You may need to press the hinges into place in steps to keep the hinges aligned. 4) Slide the latch over the box top's latch pivot pin with the slot in the latch facing the box and the latch tilted inward 45 degrees. Revision History: 3/28/2023 - Correct Hinge and Latch uploaded.