Hornady Lock-n-Load Tool Holder

thingiverse

This is a simple tool holder for my Hornady Lock-n-Load press. Its small enough to be out of the way and still be convenient. It has spots for four Allen keys and a brush. The four keys are: 5/16 - For the plate 5/32 - For the primer tube 1/8 - For the powder dispenser 3/32 - For the lock rings on the dies It uses clips I created that attach to the press arm without any tools, just push them on and the extensions will hold things in place. There are two types of clips here. One with extensions (things that stick out from the arms) of 1mm and another of extensions that stick out of 1.5mm. I have two of them because if the 1mm is too loose, you can sand the 1.5mm clip down to get things just right. I find the 1mm clip fits my press but yours may be different. Note these clips are different than the ones used for my bullet tray (https://www.thingiverse.com/thing:3139151) in that they are not angled to compensate for the angle of the arm. This allows things to be a little off to the side and not interfere with grabbing a projectile from the tray. BTW, in some of my pictures you can see the excellent case feeder remix by bartje64 located here: https://www.thingiverse.com/thing:2883143 I have also included the openSCAD files so you can edit things if you need to.