Hornady Primer Tube Wall Mount

thingiverse

This is a wall mount for holding the the primer tubes, follower rod, and pickup tubes for a Hornady Reloading Press. I assumed I would always have one of the primer tubes in the press so it only holds one of the two tubes. I printed this a couple times but the tolerances on my machine were such that all the tubes hold tight enough to stand straight up without any type of top support. If you have trouble getting the tolerances right on your machine, print two copies slightly oversized. Then, drill out the bottom of each hole in one copy and mount it a few inches above the original bottom. This will act like a stabilizer that the tubes pass through and then go into the unchanged bottom mount.