Horus Kestrel 3D

grabcad

Meet the Horus Kestrel 3D. The 3D printable version of the soon to be released carbon fiber racing airframe. This utilizes a v-tail orientation which greatly benefits yaw control with a minimal efficiency loss during hovering. Like many quadcopters, this platform can be utilized in many other ways. The flight characteristics of this airframe make the rear a little bit twitchy for the inexperienced pilot, but incredibly exciting. Thank you for your interest & feedback. Follow the developments of this and other airframes on Instagram https://instagram.com/horusinc/ Additional Hardware needed: 30mm Stand-offs (I linked gold ones from Amazon earlier) M3x6mm motor hex screws (depends on how deep you can go without contacting the coil, 6mm is based on the Sunnysky's) M3x12mm - 13pcs M3x14mm - 8pcs M3x22mm - 4pcs M3x24/25mm - 2pcs M3 Locknuts - 10pcs Plastic stand-offs at your discretion. 3 Vibration balls for Mobius Camera dampeners (http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=55649) Recommended Electronics: 4 2206/2208 Motors - Cobra, KDE or T-Motor Preferred 2 CW & 2 CCW propellers. 6x3 or 6x4.5 4 ESCs utilizing either SimonK or BLHeli firmware Naze32 or Seriously Pro F3 Flight controller 4 channel or more transmitter - FrSky Taranis recommended Copyright Sherif Manganas 2015 This is made available on GrabCAD under the Creative Commons-Share Alike-NonCommercial license.