Horus Kestrel Reinforced

thingiverse

First and foremost, this design is a remix and was inspired by the original Horus Kestrel. http://horus-drones.com/https://grabcad.com/library/horus-kestrel-3d-1 I had printed, built, and flew the original from grabcad.com and it was very fun to fly. However, I noticed some play in the rear part of the air-frame when performing yaw movements. For a printed vtail frame this is certainly to be expected. This is my attempt to mitigate but will admit it is not nearly as good as a rigid CF frame. The only parts that differ from the original are: Tail Plate Main Body Base Plate Top Plate Tail plate had been widened near the vblock section and has a M3 tie in to the main body Main body has been extended near the rear to support the tie in to the tail plate, and includes M3 tie-ins to the top plate near the front and rear of the airframe Top plate rear notch has been removed - adding in support for the tie in to the main body and includes additional zip tie slots to mount equipment on the top or bottom. Base plate has the word HORUS removed - my printers continued to make a mess for some reason trying to print this. Mobius mount:http://www.thingiverse.com/thing:1686351 My current setup is as follows @ 796 grams Flip 32 AIO DYS 20A ESC's Quanum (DYS) 2206 2000KV Motors FrSKY X8R Quanum Q58 VTX Turnigy IC-120CS CCD Camera Mobius Action Cam 2200mah LIPo Print Settings Printer: C-Bot Rafts: No Supports: Yes Resolution: 0.175 Infill: 50% Notes: Printed in PETG 3 Perimeters 4 Solid Bottom and Top 50% Infill