HOT BED/END POWER MODULE ENCLOSURE

prusaprinters

<p>I tried others design out there but cannot make it work for a 40mm of 11mm/16mm of thickness.</p> <p>So after wasting PLA, I decided to make one that work with 40mm fan with thickness of max 16mm.</p> <p>The bottom have m3 holes in a grid layout of 10mm between each holes. Should work fine for any design out there...</p> <p>This thing come with 3 STL, one for the COVER, the 2 others are the enclosure for HOT BED and HOT END. The only difference between these 2 are the name on the box :).</p> <p>I put the fan in outtake mode, so the hot air are suck outside, at the same time new air are coming from the vent holes.</p> <p>Hope you like it.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Prusa</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Prusa Clone</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.2</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>25</p></div> <p><strong>Notes:</strong></p> <p>In the image from my print I used 0.3mm layer height but it's too big because the ventilation holes are 2mm in height and the size is a little bit different on the print because it is a multiple of 0.3...</p> <p>So use at least 0.2 or lower for a better print! Please note I printed at 100mms so I could have a better print if I was going slower :).</p> <p>Also the print I have done is a little different (now the ENCLOSURE as been removed)...</p> </p></p></p> Category: 3D Printer Accessories