Hot swap 3.5" to 2.5" HDD/SSD adapter for Supermicro server

thingiverse

Printing this allows you to use a 2.5" drive in your current 3.5" drive tray. Note that 3.5-2.5 adapters usually place the small drive in the middle of the 3.5, thus it does not fit into the hot-swap slot. This project is modified/optimized for the following factors: 1. minimal size and print cost 2. minimal air flow interference 3. no restrictions regarding the thickness of the 2.5 drive 4. no materials needed (only four screws that you got for the new 2.5 drive and two of the four old 3.5 drive screws) - the hex nuts are not needed, they are replaced with the idea of repurposing the standard screws 5. ability to hold HDD/SSD in place when inserting into the slot The project is a remix of thing:2905862 , the images present the print with bottom=0 and top=0 and infill=33