Hoverboard motor coupling

cults3d

Model allows coupling two hoverboard motors to have higher performance. Only the bell is printed, the original cover can be used, and the original ball bearings. The motors can be connected using pins. It is possible to mount the original tires. IMPORTANT: the inner diameter must be correct, otherwise the magnets can not be mounted. Pay attention to shrinkage !!! the magnets MUST be glued. ideally: Assembly and then with thin-bodied 2-K adhesive use the kappillar effect ! Magnets: the old magnets can be disassembled and re-glued in the new bell. The two mounting tools are used to be able to mount the magnets, and bring them to the correct axial distance. Ideally embed the bearings hot, or mount bell warm, bearings frozen. Secure with adhesive ! I am also happy to provide the *.step files, for custom designs (quad tires, etc .) Model allows to cobine 2 hoverboard engines for more power. You only have to print the bell, and can use the orginal cover, and even orignal bearings and tires. The engines can be plugged together IMPORTANT: inner slide meter after printing has to be correct. Otherwise the magents can not be mounted. Heed the Shrink ! magnets MUST be bonded. Ideal: Assembling, and then use a low-viscous 2-K-adhesive, Use the capillary- effect. Magnets: you can use the old magnets an bond them again in the new bell. BOth Jigs are used to enable mounting the magnets and not to end in a magnet-cululation, and to positon the magnets in axial direction. Bearings a in best way: embed them HOT. or: bearing frozen, and bell heated up. Usa adhesive to lock them. If you like to have *-step-file: send an email. so you can tailor-make your own creation. (Quad-Tires, etc .)