HoverBot Nano EF-02 Front Mount

thingiverse

A front mount for the Eachine EF-02 FPV AIO camera! 20 degree camera angle. Just clears those props. The LEDs are visible from the bottom! Also, an antenna guard to protect the cloverleaf antenna. The spacer is for the rear screws, so that they come down the same as the front screws with the mount. My weight without battery is 46.21 grams. Dissatisfied with the VM275T, I wanted to try something different. I sometimes have a hard time flying outdoors with the VM275T, with the horizon nicely exposed, but the ground being completely dark. The EF-02 seemed like it might handle wide dynamic range a bit better, from videos I have seen. Plus it has a 1/3 inch CMOS! The cloverleaf antenna should provide a slightly better signal, while still being roughly the same weight as the VM275T. Tucking the camera in the front of the drone should be a nice way to keep it protected, and it makes room to put the cloverleaf antenna on top with a guard, without sticking up too much. The LEDs are on the bottom edge of the camera, with an open back, the mount still leaves them exposed! Print Settings Printer: Custom Rostock Rafts: No Supports: No Resolution: 0.2mm Infill: 100% Notes: I printed mine out of PETG. I think nylon would be okay for the camera mount, but I think the stiffer quality of the PETG is good for the antenna guard. Please note that the fit with the camera is fairly snug, so you may need to do some post-printing cleanup. Also, be very careful! It should fit nicely, but not too tight! Don't try to force it. I am not responsible for any lenses that break off!